Detection of Membrane Potential in Mycobacterium tuberculosis

Materials and Reagents

1. Mycobacterial cells (Mycobacterium tuberculosis)
   
2. 7H9 broth (Difco, catalog number: 271310 )
   
3. Glycerol (Amresco, catalog number: 0854 )
   
4. TWEEN®80 (Amresco, catalog number: 0442 )
   
5. Middlebrook ADC (albumin-dextrose-catalase) enrichment (BD Biosciences, catalog number: 211886 )
   
6. The BacLight^TM Bacterial Membrane Potential Kit (Invitrogen, catalog number: B34950 )
   Provides the following solution:
   
   1. DiOC₂ (Component A), 1.2 ml of a 3 mM solution in DMSO
      
   2. CCCP (Component B), 300 μl of a 500 μM solution in DMSO
      
   3. Phosphate-buffered saline (PBS, Component C), 10 mM sodium phosphate and 145 mM sodium chloride, pH 7.4
7. Supplenmented 7H9 broth (see Recipes)
   

Equipment

1. Incubation shaker
   
2. Laminar flow hood
   
3. Laboratory centrifuge
   
4. Flow cytometer (BD FACSVerseTM System)
   

Procedure

1. Culture the mycobacterial cells aerobically in 7H9 broth at 37 °C with shaking (200 rpm) till mid- log phase (OD₆₀₀ of 0.3).
   
2. Filter the required volume of PBS (Component C) through a 0.22 μm pore size membrane, preparing enough for culture dilution and 500 μl per test.
   
3. Allow the 3 mM DiOC₂ (Novo et al., 2000) and 500 μM CCCP solutions (Components A and B) to come to room temperature before use.
   
4. Wash the cells with 1 ml filtered PBS twice. Spin down at a speed of 4,000 rpm for 5 min for each wash.
   
5. Dilute the mycobacterial culture to approximately 1 x 10⁶ cells per ml in filtered PBS.
   
6. Aliquot 500 μl of the bacterial suspension into a flow cytometry tube for each staining experiment to be performed. Prepare two additional tubes for a depolarized control and an unstained control.
   
7. Add 25 μl of 500 μM CCCP (Component B) to the depolarized control sample and mix.
   
8. Add 3 μl of 3 mM DiOC₂ Component A) to each flow cytometry tube and mix (do not add stain to the unstained control sample). Incubate samples at room temperature for 30 min. Stained samples can be analyzed after 5 min, but signal intensity continues to increase until about 30 min.
   
9. Stained bacteria can be assayed in a flow cytometer equipped with a laser emitting at 488 nm. Fluorescence is collected in the green and red channels; filters used for detecting fluorescein and the Texas Red dye, respectively, are generally suitable. The forward scatter, side scatter, and fluorescence should be collected with logarithmic signal amplification.
   
10. Instrument adjustments are especially critical for detecting relatively small particles such as bacteria. Use the unstained control sample to locate bacterial populations in the forward and side scatter channels. Use the side scatter as the parameter for setting the acquisition trigger.
    
11. After adjusting the flow cytometer as described above, apply the depolarized control sample. Gate on bacteria using forward versus side scatter and adjust fluorescence photomultiplier tube voltages such that the green and red MFI values are approximately equal. Do not set compensation.
    
12. While the relative amount of red and green fluorescence intensity will vary with cell size and aggregation, the ratio of red to green fluorescence intensity can be used as a size-independent indicator of membrane potential. The data can also be processed by gating on bacteria using forward versus side scatter, and analyze gated populations with a dot plot of red versus green fluorescence reporting MFI values as linear values, not as channels.
    
13. On a ratiometric histogram, set markers around the peaks of interest and record the mean ratio values (Figure 1). For a dot plot of red versus green fluorescence, set regions around the populations of interest and record red and green MFI values for each. To evaluate the data, divide the red population MFI by the green population MFI.
    
14. In the flow cytometer, bacteria are identified solely on the basis of their size and stain ability.
    
    
    Figure 1. Detection of membrane potential in mycobacteria. Red/green ratios were calculated using population mean fluorescence intensities for mycobacteria, incubated with 3 μM DiOC₂ for 30 min in either the presence or absence of 25 μM CCCP.
    

Notes

1. Carbocyanine dyes, including DiOC₂ and CCCP, are inhibitors of respiration. While these dyes do not alter assay results over the recommended staining periods, both DiOC₂ and CCCP are toxic to bacterial cells and the cells will not be culturable after even brief exposure.
   
2. The cells should be washed properly and any kind of aggregation should be avoided as it might interfere with the assay. In case any aggregates are still observed, allow the tubes to stand for a while so that the clumps can settle down. The sample can be transferred to a fresh tube.
   
3. Solutions of the carbocyanine dye DiOC₂ (3,3′-diethyloxacarbocyanine iodide) and CCCP (carbonyl cyanide 3-chlorophenylhydrazone) should be protected from light.
   

Recipes

1. 7H9 broth supplemented with 0.1% glycerol, 0.1% TWEEN®80 and Middlebrook ADC (albumin-dextrose-catalase) enrichment

Acknowledgments

Dr. Amit Singh is a Wellcome- DBT India Alliance Intermediate Fellow. The work was supported by the Wellcome- DBT India Alliance grant, WTA01/10/355.

References

1. Chawla, M., Parikh, P., Saxena, A., Munshi, M., Mehta, M., Mai, D., Srivastava, A. K., Narasimhulu, K. V., Redding, K. E., Vashi, N., Kumar, D., Steyn, A. J. and Singh, A. (2012). Mycobacterium tuberculosis WhiB4 regulates oxidative stress response to modulate survival and dissemination in vivo. Mol Microbiol 85(6): 1148-1165.
   
2. Novo, D. J., Perlmutter, N. G., Hunt, R. H. and Shapiro, H. M. (2000). Multiparameter flow cytometric analysis of antibiotic effects on membrane potential, membrane permeability, and bacterial counts of Staphylococcus aureus and Micrococcus luteus. Antimicrob Agents Chemother 44(4): 827-834.
   
3. Novo, D., Perlmutter, N. G., Hunt, R. H. and Shapiro, H. M. (1999). Accurate flow cytometric membrane potential measurement in bacteria using diethyloxacarbocyanine and a ratiometric technique. Cytometry 35(1): 55-63.