Materials and Reagents
- 10 cm Petri dishes
- 50 ml Beckel centrifuge tubes
- 1.5 ml microcentrifuge tubes
- Amicon Ultra-15 centrifugal filter
- 0.45 µm immobilon-FL PVDF (EMD Millipore, catalog number: IPFL00010 )
- Wild type MEF and Rab8a-/- MEF cell lines
- MEF isolation and phenotypic analysis was previously described (Das et al., 2015)
- DEME with glucose, L-glutamine and sodium pyruvate (Mediatech, catalog number: 10-013 )
- Fetal bovine serum (FBS) (Sigma-Aldrich, catalog number: F2442-500ML )
- Pen-strep (Thermo Fisher Scientific, GibcoTM, catalog number: 15140-122 )
- Lactalbumin hydrolysate solution (50x) (Sigma-Aldrich, catalog number: 58901C-100ML )
- NaN3
- NaF
- Na3VO4
- PMSF
- DTT
- Nonidet® P40 substitute (Sigma-Aldrich, catalog number: 74385-1L )
- Bio-Rad protein assay dye reagent concentrate (Bio-Rad Laboratories, catalog number: 500-0006 )
- Tween® 20 (Thermo Fisher Scientific, Fisher Scientific, catalog number: BP337-500 )
- Sodium chloride (NaCl)
- Potassium chloride (KCl)
- Disodium hydrogen phosphate (Na2HPO4)
- Potassium dihydrogen phosphate (KH2PO4)
- Protease inhibitor cocktail tablets (Sigma Aldrich, catalog number: 11873580001 )
- Skim milk powder (EMD Millipore, catalog number: 1.15363.0500 )
- Amersham ECL Western blotting detection reagents (GE Healthcare, catalog number: RPN2209 )
- Amersham ECL Rabbit IgG, HRP-linked whole Ab (from donkey) (GE Healthcare, catalog number: NA934V-1ML )
- Wnt5a/b (C27E8) Rabbit mAB (Cell Signaling Technology, catalog number: 2530S )
- Histone H3 (D1H2) XP® Rabbit mAb (Cell Signaling Technology, catalog number: 4499S )
- 10% FBS DMEM (see Recipes)
- 1x LAH DMEM (see Recipes)
- Non-denaturing lysis buffer (see Recipes)
- 1% Tween 20 in PBS (PBST) (see Recipes)
- 5% skim milk in PBST (see Recipes)
- 1x running buffer (see Recipes)
- 1x transfer buffer (see Recipes)
Equipment
- Thermo IEC Centra CL3R Bench-model, Refrigerated centrifuge
- Avanti J-26 XP centrifuge (Beckman Coulter, model: Avanti J-26XP )
- Beckman JA-25.50 rotor (Beckman Coulter, model: JA-25.50 )
- Bio-Rad Mini-PROTEAN Tetra Cell (Bio-Rad Laboratories, model: 1658005EDU )
- XCell SureLock® Mini-Cell and XCell II blot module (Thermo Fisher Scientific, NovexTM, catalog number: EI0002 )
- QSonica XL-2000 (Qsonica, model: XL-2000 )
- Ultrospec 2100® UV-Visible spectrophotometer (Biochrom, model: 80-2112-21 )
Procedure
- Cell culture/transfection
- Culture wild type MEF and Rab8a-/- MEF cell lines in DMEM + 10% FBS until 90-95% confluent in a 10 cm Petri dish.
- Replace DMEM + 10% FBS with DMEM supplemented with 12 ml of 1x lactalbumin hydrolysate solution (LAH).
- Monitor the morphology of cells over the next 48 h.
- After 48 h, collect the conditioned media in a 50 ml centrifuge tube and spin down at 10,000 x g at 4 °C for 10 min. Transfer the supernatant into a clean tube and immediately proceed with step B1 for maximum yield. Supernatant can be frozen and used after thawing but is generally not recommended.
- Wash Petri dish with 1 ml of 1x PBS. Repeat wash.
- Subsequently add 1 ml of 1x lysis buffer to Petri dish and lay flat on ice for 15 min.
- Keeping the Petri dish on ice, collect the cell lysate using a cell scraper and transfer to a 1.5 ml microcentrifuge tube.
- Sonicate cell lysate briefly (no more than 1 or 2 sec at a time for 3 cycles) and then centrifuge at 13,300 x g at 4 °C for 10 min.
- Transfer supernatant to a clean microcentrifuge tube and store at -80 °C.
- Centrifugation of conditioned media
- Take the conditioned media and add it to the Amicon Ultra-15 centrifugal filter.
- Centrifuge the filtration device at 4,000 x g at room temperature for 90 min.
- Use a 200 µl pipette to recover the concentrate. For maximum recovery, collect the concentrate immediately. Expect roughly, 180 µl of concentrated media from collection.
- Save the concentrate at -80 °C. Aliquot can remain frozen for up to a year.
- Western blot detection
- Measure protein concentrate using Bradford assay (Bio-Rad reagent protocol). Use lysis buffer as a blank for protein measurements.
- Prepare 30 µg of total protein samples in 1x LDS sample buffer.
- Run samples in 10% SDS-PAGE gel at 80 V and immediately stop when dye runs off gel.
- Transfer protein onto a 0.45 µm PVDF membrane. Setup a transfer apparatus and run at 300 mA for 90 min.
- After transferring, take the PVDF membrane and block using 5% skim milk in PBST. Leave the membrane for blocking at room temperature on a shaker for 1 h.
- Subsequently, take the membrane and incubate overnight in a 1:1,000 dilution of anti-mWnt5a/b antibody at 4 °C. Dilute antibody in 5% skim milk in PBST.
- After 16 h of incubation in primary antibody, wash membrane in PBST and place on a shaker for 10 min. Repeat two more times for a total of three washes.
- Incubate with anti-rabbit antibody at a 1:2,000 dilution at room temperature for 1 h. Dilute antibody in 5% skim milk in PBST.
- Wash membrane in PBST and place on a shaker for 10 min. Repeat two more times for a total of three washes.
- Apply ECL reagent to membrane for 5 min.
- Proceed to expose x-ray film for 30 sec and develop.
Representative data

Figure 1. Detection of Wnt5a in conditioned media. Cell lysates and conditioned media from Rab8a+/+ and Rab8a-/- MEF visualized using anti-mWnt5a primary antibody. Histone3 was used as a control to determine contamination from cell lysate in media samples.
Recipes
- 10% FBS DMEM
950 ml DMEM with 4.5 g/L glucose, L-glutamine & sodium pyruvate
50 ml fetal bovine serum
5 ml pen-strep
- 1x LAH DMEM (50 ml)
49 ml DMEM with 4.5 g/L glucose, L-glutamine & sodium pyruvate
1 ml lactalbumin hydrolysate solution (50x)
- Non-denaturing lysis buffer
50 mM Tris-HCl (pH 7.5)
150 mM NaCl
10 mM EDTA
0.02% NaN3
50 mM NaF
1 mM Na3VO4
0.5% Np40 substitute
1 mM PMSF
0.5 mM DTT
Protease inhibitor cocktail tablets (1tablet for 10mL)
- 0.1% Tween 20 in PBS (PBST) (1 L)
1 ml Tween® 20
8 g NaCl
0.2 g KCl
1.44 g Na2HPO4
0.24 g KH2PO4
Dissolved in 1,000 ml MilliQ water, and pH adjusted to 7.4 using NaOH.
- 5% skim milk in PBST
5 g skim milk powder dissolved in 100 ml PBST.
- 1x running buffer
3.0275 g Tris base
14.4 g glycine
10 g sodium dodecyl sulfate
Dissolved in up to 1,000 ml of MilliQ water.
- 1x transfer buffer
14.4 g glycine
3.02 g Tris base
Dissolved in 700 ml of MilliQ water
Add 200 ml methanol once completely dissolved.
Acknowledgments
This work was supported by National Institutes of Health (NIH) grants [DK102934, DK085194, DK093809, CA178599]. NG is also supported by a Research Scholar Grant [RSG-15-060-01-TBE] from the American Cancer Society.
References
- Das, S., Yu, S., Sakamori, R., Vedula, P., Feng, Q., Flores, J., Hoffman, A., Fu, J., Stypulkowski, E., Rodriguez, A., Dobrowolski, R., Harada, A., Hsu, W., Bonder, E. M., Verzi, M. P. and Gao, N. (2015). Rab8a vesicles regulate Wnt ligand delivery and Paneth cell maturation at the intestinal stem cell niche. Development 142(12): 2147-2162.
Article Information
Copyright
© 2016 The Authors; exclusive licensee Bio-protocol LLC.
Category
Biochemistry > Protein > Immunodetection
Cell Biology > Cell signaling > Development