2.6. Fabrication of the ECDs

Tzi-Yi Wu

Improve Research Reproducibility A Bio-protocol resource

Home
Protocols

Concise Method

2.6. Fabrication of the ECDs

TW Tzi-Yi Wu

This method is extracted from research article: Polymers (Basel), Oct 2017

Poly(tris(4-carbazoyl-9-ylphenyl)amine)/Three Poly(3,4-ethylenedioxythiophene) Derivatives in Complementary High-Contrast Electrochromic Devices

DOI: 10.3390/polym9100543

Ask a question

Favorite

The ECDs were constructed using two complementary polymer layers, PtCz as the anodically coloring layer, PEDOT, PProDOT-Me₂, or PProDOT-Et₂ as the cathodically coloring layer. PtCz, PEDOT, PProDOT-Me₂, and PProDOT-Et₂ films were deposited on ITO substrates (active area: 1 cm × 1.5 cm). The ECDs were fabricated by arranging the oxidized and reduced films to face each other, and they were separated by an electrolyte. The fabrication procedures of ECDs are shown in Figure 1.

The fabrication procedures of electrochromic devices (ECDs).

Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/).

Do you have any questions about this protocol?

Post your question to gather feedback from the community. We will also invite the authors of this article to respond.

Post a Question

0 Q&A

Share your protocol with your peers.

Submit a Preprint Protocol