Improve Research Reproducibility A Bio-protocol resource
- Home
- Protocols
-
Ask a
question
Favorite
The water contact angle test was performed to measure the hydrophilicity of both PLA and PLA-SF meshes. First, the meshes were adhered to the cover slide, which ensured that the meshes were flat. Second, 5 μL deionized water was dropped onto the meshes. Third, photos were captured by a digital microscope (U500X, Denmark). Finally, the contact angle was determined by using ImageJ software.
Copyright and License information: ©2023 The Authors
This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).
Do you have any questions about this protocol?
Post your question to gather feedback from the community. We will also invite the authors of this article to respond.
Post a Question0 Q&A
