DTG concentrations were determined using a LC-MS/MS, LCMS-8030 system (Shimadzu, Kyoto, Japan). Analytes were separated isocratically on a reverse phase C18 column (1.5 × 50 mm, 5 μm, Inertsil® ODS-3, GL Science, Tokyo, Japan) with 5 mM formic acid-25% (v/v) ethanol at a flow rate of 0.2 mL/min. The column temperature was maintained at 40°C and the sample plate was kept at 4°C. The analytes were detected using positive electrospray ionization mode with multiple reaction monitoring (MRM). The injection volume was 1 μL, and the total analysis time for each sample was 6 min. Argon was used as the nebulizer and desolvation gas. The gas temperature, nebulizing gas flow, drying gas flow, capillary voltage, and collision energy were set at 250°C, 3.0 L/min, 15.0 L/min, 6000 V, and −30 V, respectively. Precursor to product mass transitions for DTG and DTG-d5 were 420/127 and 420/132 (m/z), respectively. LabSolutions software (Shimadzu, Tokyo, Japan) was used for system control and data analysis.

Note: The content above has been extracted from a research article, so it may not display correctly.



Q&A
Please log in to submit your questions online.
Your question will be posted on the Bio-101 website. We will send your questions to the authors of this protocol and Bio-protocol community members who are experienced with this method. you will be informed using the email address associated with your Bio-protocol account.



We use cookies on this site to enhance your user experience. By using our website, you are agreeing to allow the storage of cookies on your computer.