Fabrication of the MXCC/PC bilayer-structured actuator
This protocol is extracted from research article:
Leaf-inspired multiresponsive MXene-based actuator for programmable smart devices
Sci Adv, Jul 12, 2019; DOI: 10.1126/sciadv.aaw7956

The MXCC/PC bilayer-structured actuator was fabricated by filtering the MXCC ink on a PC filter membrane (Millipore GTTP) with a pore size of about 220 nm. The patterned actuator was fabricated with the help of a mask during the filtering process. The MXene/PC and cellulose/PC bilayer-structured actuators were also prepared on the PC filter membrane with the same parameters for comparison purposes. The actuators were rinsed with DI water after filtration. Last, the actuators were left in air at ambient temperature for 2 hours to dry. Solution filtering of the MXCC ink was also performed on an A4 size paper as a membrane.

Note: The content above has been extracted from a research article, so it may not display correctly.



Q&A
Please log in to submit your questions online.
Your question will be posted on the Bio-101 website. We will send your questions to the authors of this protocol and Bio-protocol community members who are experienced with this method. you will be informed using the email address associated with your Bio-protocol account.



We use cookies on this site to enhance your user experience. By using our website, you are agreeing to allow the storage of cookies on your computer.