TA powder (25 g) was added to a vial and then heated at 70°C in an oil bath. A yellow transparent low-viscosity liquid was obtained after 1 min, and then the stirring was started. DIB (5 g, 20 wt %) was injected under stirring, and the mixture was stirred at 70°C for 5 min. Subsequently, a certain amount of FeCl3 [determined by the molar ratio of TA to iron(III)] was added to the mixture under violent stirring. The liquid mixture was then easily poured into the desired mold, and the yellow transparent solid copolymer was obtained after cooling down to room temperature.

Note: The content above has been extracted from a research article, so it may not display correctly.



Q&A
Please log in to submit your questions online.
Your question will be posted on the Bio-101 website. We will send your questions to the authors of this protocol and Bio-protocol community members who are experienced with this method. you will be informed using the email address associated with your Bio-protocol account.



We use cookies on this site to enhance your user experience. By using our website, you are agreeing to allow the storage of cookies on your computer.